Blog

Driveway lighting: what to fit and how the power gets there

· 3 min read · Fins Up Electrical, licence 91921

5.0 on GoogleLicence 91921Open 24 hours, Mon to SatFree quotes

Most driveways are lit with low bollards along the edge, in-ground lights set into the concrete or garden, wall lights on the house or fence, or a sensor floodlight over the garage. The right pick depends on where the cable can run, how much light you want, and how close you are to the bay.

Which driveway lights work best?

  • Bollards. Short posts along the edge. They light the ground and mark the line of the driveway at night.
  • In-ground lights. Set flush into a garden bed or the concrete. Good for a long driveway, though they need a sealed fitting that copes with water sitting on top.
  • Wall lights. On the house, a retaining wall or the front fence. The cable run is usually shorter.
  • Sensor floodlights. Bright light when a car or person moves through. Best near the garage or the front door.

A lot of homes mix two. Bollards for the look, and a sensor flood for when you pull in late.

How does the power get to driveway lights?

Lights away from the house need a cable run, usually underground in conduit back to the switchboard or an existing circuit. That’s the part that sets how big the job is. A wall light on the house might need a short run through the wall. Bollards at the far end of a long driveway need a trench.

Before anyone digs, the location of buried services should be checked through Before You Dig Australia. Underground cable for outdoor lighting has to be laid and protected to the wiring rules, and in Queensland that’s work for a licensed electrician.

What lights hold up near the bay?

On the Redcliffe peninsula the salt in the air eats cheap fittings. Steel screws rust, painted housings bubble and seals perish. For homes in Scarborough, Woody Point or Margate we look for marine grade or stainless fittings, sealed bodies with a high IP rating, and plastic or coated fixings. A fitting that costs a bit more up front tends to outlast two cheap ones by the water.

Should driveway lights be on a sensor, a timer or a switch?

It comes down to how you use the driveway. A sensor suits a floodlight over the garage, since it only comes on when someone’s there. Bollards and garden lights look best on a timer or a dusk sensor, so the front of the house is lit every evening without anyone touching a switch. You can also put them on a switch inside the front door. We’ll talk through which makes sense for your place when we quote.

Do driveway lights help with security?

Good lighting at the front of a house makes it easier to see who’s there and harder to approach unseen. We wrote up what the research says in our post on outdoor lighting and burglars. For security, a sensor flood near the garage usually does more than soft bollard light along the edge.

Who installs driveway lights on the peninsula?

Driveway lights are one of the jobs we do. Andrew runs the cable, fits the lights and sets up the switching, and you get a free fixed quote before any work starts. Fins Up Electrical is licensed, number 91921. See our shed and outdoor power page for the rest of the outdoor work we do.

Want this sorted? Shed and outdoor power from Fins Up.

Licensed electrician, licence 91921. Free quote before any work starts. Open 24 hours Monday to Saturday.

Common questions

Can I install solar driveway lights instead?

Solar lights with no connection to the house wiring don’t need an electrician. They’re usually dimmer, and the panels lose output under trees or after a few cloudy days.

Do driveway lights need a trench?

Lights away from the house usually do. The cable runs underground in conduit. Lights mounted on the house or a nearby wall can often be fed with a much shorter run.

Can I run the cable myself and get an electrician to connect it?

No. Laying fixed wiring is electrical work, and in Queensland it has to be done by a licensed electrician.

Sources

The service