Shop fit-out electrical: what to plan before you open
Planning electrical for a shop fit-out: power for counters and equipment, lighting, the switchboard, and when to bring the electrician in so opening day holds.
How to test a safety switch, and how often
How to test a safety switch: press the T button every three months, what should happen when you do, and what it means if the switch won’t trip or won’t reset.
Fishy smell in the house: when it’s electrical
A fishy smell with no fish in the house can be an overheating power point, switch or fitting. Why plastic smells like fish when it gets hot, and what to do.
Signs your house needs rewiring
Warm switches, flickering lights, old fuses and crumbling cable are the usual signs a house needs rewiring. What each one means and who should check it in QLD.
Sensor light stays on: why it happens and what to do
Sensor light stays on all the time? Usually it’s in manual override, set too sensitive, or the sensor has failed. What you can check and when to call us.
Can electrical faults cause a house fire?
Can electrical faults cause fires? Yes. Loose connections, overloaded boards and covered downlights heat up. The warning signs and what to do about them.
What causes electrical faults in a house
What causes electrical faults at home? Loose connections, worn appliances, water, old wiring and overloaded circuits. How each one shows up and what to do.
Photoelectric vs ionisation smoke alarms: which one QLD homes need
Photoelectric vs ionisation smoke alarms: how each one senses smoke, why Queensland law now needs photoelectric, and how to tell which type is on your ceiling.
Driveway lighting: what to fit and how the power gets there
Driveway lighting options for Queensland homes: bollards, in-ground lights, wall lights and sensor floods, how the cable gets there, and what suits salt air.
How to get power to a shed
How to get power to a shed in Queensland: underground or overhead cable, a sub-board, solar for light loads, and why a licensed electrician does the wiring.
Do you need an electrical inspection when buying a house in Queensland?
Electrical inspection when buying a house in QLD: what it checks, the 90-day safety switch rule for buyers, and what the seller disclosure doesn’t cover.
Choosing a ceiling fan for a coastal home
Choosing a ceiling fan for a coastal home: salt air eats metal and warps timber. What blade, body and finish to look for, and the warranty fine print to check.
Kitchen renovation electrical work: what’s involved
Kitchen renovation electrical work, step by step: disconnect, rough-in, fit-off, the cooktop and oven circuits, lighting and the switchboard checks to do first.
Is DIY electrical work legal in Queensland?
Is DIY electrical work legal in Queensland? No. What counts as electrical work, what a homeowner can do, the penalties, and what it means for insurance.
Ceiling fan wobbling: what causes it and when to worry
Ceiling fan wobbling? Usually loose blade screws, unbalanced or bent blades, or a loose mounting. What you can safely check and when it needs an electrician.
Electrical planning for a new build: what to decide before the frame goes up
Electrical planning for a new build: what to decide before the frame goes up, from power points and lights to EV charging, data and the switchboard size.
How much does an electrician cost?
How much does an electrician cost? What drives the price of electrical work, why fault finding is hard to price upfront, and how to keep your bill down.
Can I install my own ceiling fan in Queensland?
Can you install your own ceiling fan in Queensland? No. It’s electrical work that must be done by a licensed electrician. What the law says and what you can do.
Induction cooktop installation: circuit and switchboard checks
Induction cooktop installation explained: why it needs its own circuit, when the switchboard or supply needs work, and what to check before you swap from gas.
Ceiling fan installation cost: what changes the price
What sets ceiling fan installation cost: swap or new point, roof access, ceiling height, controls and fan type. How to keep it down, plus a free fixed quote.
What counts as an electrical emergency?
What counts as an electrical emergency? Smoke, sparks, shocks, exposed wires and water in electrics. Who to call first in QLD, and what can wait till morning.
What is electrical fault finding?
What is electrical fault finding? How a licensed electrician tracks down trips, dead circuits and flicker, what you can do first, and what happens next.
Safety switch vs circuit breaker: what’s the difference?
Safety switch vs circuit breaker: one protects people from electric shock, the other protects wiring from overload. How to tell which ones your switchboard has.
Can I install my own oven in Queensland?
Can you install your own oven in Queensland? A plug-in oven on a suitable point, yes. A hardwired oven must be connected by a licensed electrician. Here is why.
Power point not working? Here’s what to check
Power point not working? Check the appliance, the switch and the switchboard first. If it’s still dead, here’s what’s likely wrong and who should fix it.
Old ceramic fuse box replacement: what you need to know
Still on an old ceramic fuse box? Why fuse wire boards fall short, the QLD safety switch rules for sales and rentals, and what replacing the board involves.
Can I install my own EV charger?
Can you install your own EV charger in Queensland? No. A wall charger is hardwired electrical work that needs a licensed electrician. Here is why and what to do
Switchboard upgrade cost: what changes the price
What sets the cost of a switchboard upgrade: board size, number of circuits, safety switches, asbestos, faults found on the day and access. Free fixed quote.
EV charger installation cost at home: what changes the price
What drives the cost of a home EV charger install in Queensland: the charger, cable run, switchboard, supply checks and Energex. Free fixed quote up front.
Burning smell from a power point
Burning smell from a power point? Stop using it now. What causes it, what to do in the next five minutes, and why it needs a licensed electrician today.
What is a switchboard upgrade?
What is a switchboard upgrade? Old fuses or breakers come out, modern circuit breakers and safety switches go in. What’s involved, how long it takes, and why.
EV charger installation requirements in Australia, for Queensland homes
EV charger installation requirements for Queensland homes: wiring rules, switchboard and supply checks, the October 2026 Energex change, and who installs it.
Are flickering lights dangerous?
Are flickering lights dangerous? Some flicker is harmless, some means a loose connection that can start a fire. The warning signs and what to do right now.
Does outdoor lighting deter burglars?
Does outdoor lighting deter burglars? What the research on lighting and crime shows, what it does not prove for homes, and how to light a property so it helps.
Why are the lights flickering in one room?
Lights flickering in one room? Usually a loose globe, an LED that doesn’t suit the dimmer, a failing driver or a loose connection. What to check and when.
Do I need to upgrade my switchboard?
Do you need to upgrade your switchboard? Ceramic fuses, no safety switches, tripping breakers, heat or burning smells are the signs. What each one means in QLD.
Selling a house in QLD: smoke alarm compliance before you list
Selling a house in QLD? The smoke alarms must comply before the sale and you must declare it on the transfer form. Plus the safety switch rule sellers forget.
Why are the lights flickering in my whole house?
Lights flickering in the whole house? It’s usually the supply, a loose main neutral or switchboard connections. How to tell, who to call and when it’s urgent.
Downlights in insulated ceilings: what’s safe and what isn’t
Downlights in insulated ceilings: what IC-rated means, why old halogens under insulation are a fire risk, and what to check in your roof space and what to fix.
Smoke alarm beeping or chirping: what it means and what to do
Smoke alarm beeping or chirping every minute? It’s usually a low battery or an alarm at the end of its life. What each sound means and when the alarm must go.
Why does my hot water system keep tripping the safety switch?
Hot water safety switch keeps tripping? A failing element is the usual cause, often overnight on off-peak. What you can check and why it needs an electrician.
Replacing halogen downlights with LED
Replacing halogen downlights with LED: when a new globe works, when the whole fitting should go, and why old halogens and ceiling insulation are a fire risk.
Safety switch tripping when it rains
Safety switch tripping when it rains? Water is getting into outdoor points, lights or underground cable. What to check safely and how we fix it for good.
How many downlights do I need?
How many downlights you need depends on room size, ceiling height, beam angle and what the room is for. A guide to spacing and layout from a licensed sparky.
Do smoke alarms need to be hardwired in Queensland?
Do smoke alarms need to be hardwired in QLD? Not always. When a 10-year battery alarm is allowed, when hardwired is required, and who can legally install them.
Why does my safety switch keep tripping at night?
Safety switch keeps tripping at night? Off-peak hot water, pool timers, fridges and dew are the usual causes. How to narrow it down and when to call for help.
How many power points do you need in a kitchen renovation?
How many power points a kitchen renovation needs: count your appliances, then plan the bench, island, pantry and appliance points before the walls are closed.
How many smoke alarms do I need in Queensland?
How many smoke alarms you need in QLD: one in every bedroom, hallways linking bedrooms, and every storey. Worked examples for common Queensland home layouts.
Smoke alarm requirements for Queensland rental properties
Smoke alarm requirements for QLD rentals: what landlords must install, what to test within 30 days of each lease, and what tenants handle. Official rules.
Safety switch keeps tripping with nothing plugged in
Safety switch tripping with nothing plugged in? The fault is in the fixed wiring, a fitting or hard-wired gear. What it means and what to do next in QLD.
Outdoor power point installation: what you need to know
Outdoor power point installation explained: what an IP rating means, why safety switch protection matters, and where to put the point. Licensed, free quote.
Smoke alarm laws in QLD: what every home needs by 1 January 2027
Queensland smoke alarm laws hit every home on 1 January 2027. Photoelectric, interconnected, AS 3786-2014, in every bedroom. Here’s what your home needs now.
Why does my safety switch keep tripping?
Safety switch keeps tripping? Find the faulty appliance safely, learn the common causes, and know when it’s time to call a licensed electrician in QLD.
Power point installation cost: what changes the price
What sets the cost of a new power point in Queensland: the cable run, your switchboard, safety switches and outlet type. Free fixed quote before we start.