A sensor light that stays on is usually stuck in manual override, set with a long timer or high sensitivity, or has a failed sensor. Override is the common one: flicking the wall switch off and on quickly tells many sensor lights to stay on until you reset them.
What is manual override on a sensor light?
Many sensor lights have an override mode built in. Switch the light off and back on within a second or two at the wall and the light ignores the sensor and stays on. It’s there so you can keep the light on while you’re out the back. It also gets triggered by accident, by kids, or by a brief power flicker.
To reset it, turn the wall switch off, leave it off for about a minute, then turn it back on. Check the instructions for your model, since the timing varies.
Could the settings be wrong?
Most sensor heads have small dials underneath. One sets how long the light stays on after the last movement. One sets sensitivity or range. Some have a third for how dark it has to be before the sensor works. If the timer is wound right up, the light can look like it never goes off. If sensitivity is high, a tree moving in the wind, a passing car or the neighbour’s cat keeps setting it off.
Turning those dials is fine for a homeowner. Taking covers off or touching the wiring is not.
What else keeps a sensor light on?
- Heat sources in view. Air conditioner units, a barbecue or a hot driveway can trigger a heat sensor.
- Moving plants. Palms and shrubs in front of the sensor move all night in a sea breeze.
- A faulty sensor. Salt, moisture and sun wear out the sensor head on homes near the water.
- Wiring or a bypass. A switch wired to bypass the sensor, or water in the fitting, can hold the light on.
When should an electrician look at it?
Call us if a reset and the dials don’t fix it, if the fitting has water inside it, if it buzzes or flickers, or if it trips the safety switch. Those point to a failed sensor or a wiring fault. Replacing the fitting or the sensor head is electrical work, and in Queensland that has to be done by a licensed electrician.
Is it worth replacing an old sensor light?
Often, yes. A newer LED sensor light draws far less power, and you can pick a sealed fitting built for coastal air. If the housing is rusted or the lens has gone cloudy, replacement usually beats repair. Fins Up Electrical replaces sensor lights and floods across the Redcliffe peninsula and Moreton Bay, and Andrew gives you a free fixed quote before any work starts. See our lighting installation page.
Want this sorted? Lighting installation from Fins Up.
Licensed electrician, licence 91921. Free quote before any work starts. Open 24 hours Monday to Saturday.
Common questions
Why does my sensor light come on by itself at night?
Usually something moving or warm in its range: plants in the wind, an animal, a car going past, or an air conditioner unit. Turning the sensitivity down or angling the head away often fixes it.
How do I reset a sensor light?
On many models, turn it off at the wall switch for about a minute, then back on. That clears manual override. Check your model’s instructions.
Can I replace the sensor head myself?
No. It connects to the fixed wiring, so in Queensland it has to be replaced by a licensed electrician.