Blog

How many power points do you need in a kitchen renovation?

· 3 min read · Fins Up Electrical, licence 91921

5.0 on GoogleLicence 91921Open 24 hours, Mon to SatFree quotes

There’s no single number. Count every appliance you’ll use on the bench, add the ones that live in cupboards and under the bench, then add a few spare. For most family kitchens that means several double points along the bench, points in the island if you have one, and dedicated points for the fridge, dishwasher and microwave. Plan it before the walls are closed in, because adding points later costs more.

How do I work out how many points I need?

Walk through how you use the kitchen. Write down everything that plugs in:

  • On the bench: kettle, toaster, coffee machine, blender, air fryer, mixer, phone chargers.
  • Built in or hidden: fridge, dishwasher, microwave, rangehood, under-cabinet lights, a wine fridge.
  • Occasional: slow cooker, sandwich press, food processor.

Anything that stays plugged in all the time gets its own outlet. Things you use together, like the kettle and toaster at breakfast, need to be plugged in at the same time without unplugging something else. That’s the count. Then add spare for the appliance you’ll buy in two years.

Where should the bench points go?

Spread them along the bench so no stretch of bench is out of reach. Put points where you’ll set up each appliance. The coffee machine near the fridge for milk. The kettle near the sink for water. The toaster away from the overhead cupboards.

Keep points clear of the sink, the cooktop and the corners where a plug would sit hard against a wall. A double is almost always better than a single. USB points beside where phones and tablets end up save hunting for chargers.

Do I need power points in the island bench?

If you’ll use the island for prep, homework or a laptop, yes. An island without power ends up with leads stretched across the walkway. Points can go on the end panel, the side facing the stools, or a pop-up unit in the benchtop.

The cable for an island has to come up through the floor, so it needs to be planned before the slab is poured or the floor is down. On a renovation with an existing floor, we look at what’s below to find the best path.

Which kitchen appliances need their own circuit?

Ovens and cooktops are usually hardwired on their own circuit, sized to the appliance. Induction cooktops in particular draw a lot of current. Check the install manual for the circuit rating it calls for.

The fridge is often put on its own point so a tripped circuit elsewhere doesn’t cut it. Dishwashers and microwaves usually plug into their own points too. A kitchen with lots of high-draw appliances may need more than one power circuit so the coffee machine, kettle and air fryer can all run without tripping. We work that out when we see the plan. Our oven and cooktop installation page covers the cooking side.

Will my switchboard handle a new kitchen?

Older switchboards often don’t have room for new circuits, or have no safety switch on some circuits. In Queensland, when power or lighting circuits are added, they need safety switch protection. A big kitchen upgrade is a common reason for a switchboard upgrade. Better to find out at the quote than halfway through the job.

When should the electrician be booked in a renovation?

Early. The cabinet maker’s drawings tell us where every bench, appliance and cupboard sits, and the points get set out to match. The cable goes in after demolition and before the plaster and splashback. Points get fitted off once the cabinets and benchtops are in.

Installing power points is licensed electrical work in Queensland. Fins Up Electrical works to your builder’s or cabinet maker’s program, and we will walk the plan with you before quoting. Quotes are free and fixed. Licence 91921.

Want this sorted? Power point installation from Fins Up.

Licensed electrician, licence 91921. Free quote before any work starts. Open 24 hours Monday to Saturday.

Common questions

Is there a minimum number of power points for a kitchen in Australia?

There’s no set number of points a kitchen must have. Plan from the appliances you use, then add spares.

Can power points go in a tiled splashback?

Yes. They’re set out before tiling so the tiler can cut around them neatly.

Do I need a separate circuit for an induction cooktop?

Usually yes. Induction cooktops draw a lot of current and are normally hardwired on their own circuit sized to the unit.

Should I add USB points in the kitchen?

They’re handy where phones and tablets end up, like the end of the bench or the island. They replace a standard double, so you don’t lose an outlet.

Sources